Casio SF-8350, Руководство по обслуживанию и список запасных частей

Страница: 28 / 37

— 27 —
6. SB-60/SB-62 cable interface check
I/F 1 TRANSMIT
2 RECEIVE
3 LOOP
4 ASCII
7N9
EXECUTING !
The TEL to SCHEDULE keys are used to select mode; the
CALENDAR, HOME TIME and WORLD TIME key are used
to set the transmission paraments. The three charactors that
appear on the right side at display represent the parameter.
In the case of the exampledisplay, it indicates 7 BIT, NON
PARITY, 9600 BPS. The operation continues until stopped by
pressing the ESC key and then pressing the ON key for all
modes.
EXECUTING !
BUZZER 1 BEEP
2 ALARM 1
3 ALARM 2
Sound can be stopped by pressing the any key.
While an alarm is sounding the screen display is as shown at
left. If an irregularity is found in voltage of battery while the
alarm is sounding, the alarm will stop. After 256 seconds, the
alarm will stop automatically.
TEL key : Key input sound every 1 second
Business card key : Sound alarm 1
MEMO key
: Sound alarm 2
To communicate two machines, please set the transmission machine before setting the receiving unit.
To release communication, press ESC button. In this case, the break code is sent to receive units.
Therefore, both machines display "TRNS BREAK !" and communication will be stopped. Also, if the error
is occurred, both machines display "TRNS ERROR !" and communication will be sttoped.
WORLD TIME key : Switch the transmission speed : 9600(9)—4800(4)—2400(2)—1200(1)
HOME TIME key : Switch the parity bit : NON(N)—EVEN(E) —NON(N) —ODD(O)
CALENDAR key : Switch the data length 7 bit(7) or 8 bit(8)
DISP CHNG key : Return to menu mode
TEL key : Transmission mode. The data of transmission
is "H"and it is sent out by the data of &H34 and
&H38 by the Xon/Xoff control.
Business card key : Reception mode. Make sure to set the
parameter to match that of the transitting side.
The data received appears on the display.
MEMO key : Loop back test. Short the Tx and Rx terminals
for this test. Transmit and check from &H20 to
&H7E. When complete, the message 'CHECK
COMPLETE' is displayed.
SCHEDULE key : output the following ASCII code by Xon/
Xoff control.
!"#*+,-/0123456789:
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
A line end code is added with each line.
5. Buzzer check
Parameter