Important!
•
When removing the stopper, carefully and slowly raise it straight upwards. Pulling
on the stopper with strong force can cause the stopper to break and leave part of
it inside one of the tape wheels, which can cause tape rotation problems and faulty
printing.
5.
Check the condition of the tape and the ink ribbon.
Important!
•
Tape once pulled out of the cartridge cannot be pushed back in.
•
Do not apply excessive force when pulling on the tape. Doing so can break or
otherwise damage the ink ribbon.
•
Loading a tape cartridge whose ink ribbon is slack can cause cutting of the ink
ribbon and other malfunctions.
Take up any slack in the ink ribbon.
•
If there is slack in the ink ribbon, insert a pencil or
similar object into the upper right wheel (“a” in the
nearby illustration) and rotate in the direction
indicated by the arrow. Rotate until the lower left
wheel (“b” in the illustration) starts to rotate. Note that
the tape does not move along with the ink ribbon at
this time.
a
b
4.
Remove the stopper
attached to the tape
cartridge.
Stopper
Tape guide
Tape
(Pull out about 3 cm)
Ink ribbon
(under the tape)
•
Make sure the leading
end of the tape is not
bent. If it is, use
scissors to trim off the
bent part.
•
Make sure the leading
end of the tape is
passing through the
tape guide.
•
Make sure there is no
slack in the ink ribbon.
21
Содержание LABEL IT! KL-BT
Страница 41: ......
