45
2
Shutting Down the Power
This section describes various ways to turn off the power.
Select “Shut down”, “Restart”, “Stand by” or “Hibernate” from the Start
menu.
The following ways are also available.
•
Slide the power switch so that the unit enters the “Stand by”,
“Hibernate” or “Shut down” mode. However, if you keep sliding the
power switch for more than 4 seconds, the system is quit forcibly and
the power is turned off (
see “Preferences “ on page 90
).
•
Close the display panel so that the unit enters the “Stand by” or
“Hibernate” mode.
The amount of power FIVA consumes when the power is turned off and
the time until Windows Me is reactivated differs in each of these power
save modes.
Fully understand the features of each of these power save modes, and
select the mode that best suits your particular requirements.
Mode
Storage
Time Unit
Power
Indicator Lamp
for state
Recovery
Consumption
Power Off
None
Long (restart)
Almost zero
Off
Standby
Memory
Fast
Yes
Flashing
Hibernation
Hard Disk
Long
Almost zero
Off
N o t e
FIVA’s default settings cause it to enter the
Standby
Mode if you do not
perform any key or thumb pad operation for about 10 minutes under
battery power alone. After another 10 minutes continuously without
operation, FIVA enters the
Hibernation
Mode.
Important
FIVA with the power source only from battery pack may not completely
recover if left in the
Standby
Mode for a very long time. If you do not
plan to use FIVA for a long time, turn it off or put it in the
Hibernation
Mode.
