Note
●
If you specified TARGET as the target
time type, you should also specify the
target time.
l
Configuring TARGET Time
Settings
●
Changing the target time type while a
stopwatch measurement operation is
stopped will reset the stopwatch time
to all zeros.
●
Configuring TARGET Time Settings
If you specified TARGET as the target time
type, perform the procedure below to specify
the target time.
●
The TARGET time value must be 30
seconds or greater.
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to specify the TARGET
time.
Note
●
Changing the TARGET time while a
stopwatch measurement operation is
stopped will reset the stopwatch time
to all zeros.
●
Enabling or Disabling Alert Sounds
You can configure a setting so the watch
beeps when the lap time reaches the target
time during measurement.
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to enable or disable the alert
sound.
Note
●
Changing the alert sound setting while
a stopwatch measurement operation is
stopped will reset the stopwatch
measurement value to all zeros.
Viewing Stopwatch Data
This section explains how to send lap times
(up to 200 records) that are stored in watch
memory, as well as other data to your phone
for viewing with EDIFICE Connected.
●
Sending Stopwatch Data to a Phone
Use the procedure below to send data from
the watch to a phone.
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to transfer data measured
by the watch to the phone.
After data transfer is complete, a list of the
measurement data will appear on the
phone display.
●
Tapping a stopwatch data item displays
its details.
●
Checking a Lap Time
Use EDIFICE Connected to check the data
you sent to the phone.
1.
Y
Tap the “EDIFICE Connected” icon.
2.
Y
Perform the operation shown on the
phone screen to view the measurement
data you want.
Note
●
Tapping “Edit” displays a screen that
you can use to change the data item
title and to delete lap time data.
Operation Guide 5537
6