SECTION 10 -- ENGINE -- CHAPTER 1
37
6- 62730
-- 04 -- 2004
33. Unscrew all of the clutch casing -- engine bolts
and detach the engine.
34. To re--fit the engine, proceed as follows.
CAUTION
Always use appropriate tools to align fixing holes.
NEVER USE FINGERS OR HANDS.
-- Apply the torque settings listed on page 20.
-- Before refitting the engine to the clutch box care-
fully clean the mating surfaces and apply sealing
compound (0.0787 in. (2 mm) diameter), accord-
ing to the diagram shown Section 21, Chapter 1,
page 29.
-- Fit the engine on the clutch casing.
-- Re--fit the front axle support assembly on the en-
gine.
-- Carry out operation
23 101 26
Propeller shafts
and guard, only installation (see Sect. 23).
-- Connect the brake piping.
-- Connect the wires to the starter motor and posi-
tion the other wires on the engine.
-- Assemble all hydraulic pipes and hoses.
-- Carry out operation
10 254 44
Exhaust pipe, only
installation (see Sect. 10).
-- Assemble the hydraulic pump feed piping, com-
plete with the relative support bracket.
-- Connect the lower radiator sleeve to the rigid
pipe.
-- Place the inlet sleeve on the turbocharger and
secure in position.
-- Connect the electrical connections to the
clogged air filter sensor.
-- Connect the injection pump fuel supply piping.
-- Connect the steering sensor wire.
-- Fit the hydrostatic steering piping to the radiator.
29
-- Connect the hydrostatic steering piping.
-- Connect the brake piping on the front axle.
-- Connect and secure the main fuel tank/extra fuel
tank piping.
-- Connect the upper radiator sleeve.
-- Attach the radiator bracket.
-- Connect the fuel return piping to the fuel tank.
-- Position the front guard and connect the head-
lamps and direction indicator electrical connec-
tions.
-- Screw the plug on the rear transmission casing
and fill up with oil (see page 6, Sect. 00 for pre-
scribed products and quantities).
-- Carry out operation
90 114 20
Removable front
roll bar, only re--assembly (see sect. 90) (models
with platform).
-- Carry out operation
90 110 36
Platform assem-
bly, only installation (see Sect. 90) (models with
platform).
-- Carry out operation
90 150 10
Cab with platform
unit, only installation (see Sect. 90) (models with
cab).
-- Fill up the engine cooling system (see page 6,
Sect. 00 for prescribed products and quantities).
-- Fill up the fuel tank (see page 6, Sect. 00 for pre-
scribed products and quantities).
-- Bleed the brakes (see Sect. 33).
