Case IH 84336239, Руководство оператора

Страница: 87 / 179

SECTION 2 - CONTROLS, INSTRUMENTS AND OPERATION
2ï29
Route the other, dual, cable looms inside the tractor
cab.
The cable loom with the two orange wires have to be
routed to any suitable electrical source which delivers
12 volts only after switching on the tractor ignition
key. For most tractors route the cable to the fuse box
). Refer to the tractor's operator's manual (
47
Install the monitor in a convenient location in the
tractor cab, within reach of the operator, preferably to
the right-hand side of the tractor seat.
Connect the remaining wiring loom (with connector)
to the monitor wiring loom.
48
When adjusting, cleaning, lubricating or carrying out
repairs, the baler must be completely stopped.
Disengage the PTO, stop the tractor engine, remove
tractor starting key, engage the baler flywheel brake
and lock the knotter tripping mechanism.
Position 1 : On the front of the RH twine box. Close
to the control box where you can check if for instance
a relay is working or not.
49
From position 1: the monitor can be lifted onto the
service platform (2).
Position 2: On top of the knotter handrail pointing
forward or back. For adjustment of the pre-load of the
load cell and the knotter mistie sensors.
When not in use, box up the monitor and place in the
toolbox for storage during winter, and/or if the baler
is parked or moved from place to place.
2
50