CASE CONSTRUCTION CX37C, Руководство оператора, Страница: 104 / 228

4 - OPERATING INSTRUCTIONS
7. After two seconds, check that all the lights on the in-
strument cluster turn OFF, except the engine oil pres-
sure warning light
(4) and the battery charging warning
light (5) .
8. If the ESL mode is set to the Always, enter the pass-
word to start the engine.
If the password has failed 5 times, please wait 10 min-
utes before re-attempting to enter the password.
(Refer to page
4-1 )
SMIL16MEX1501AA
3
9. If the ambient temperature is below 10 °C ( 50 °F ),
turn the starter key (3) to the HEAT position.
SMIL16MEX0400AA
4
10. Sound the horn with the button on the right–hand con-
trol lever to warn that the machine is starting up.
11. Turn the starter key to START position when the en-
gine preheat light (6) disappears.
The engine running takes approximately 1 s to stabi-
lize after it has been cranked up.
Release the starter key as soon as the engine is run-
ning regularly.
SMIL16MEX1501AA
5
NOTICE: the cranking up of the engine may be difficult in severe winter climates. If the engine does not start after
10 s of operation of the starter motor, turn the key to OFF position and wait 2 min before attempting a new cranking.
NOTICE: when the engine is started in severe winter climates, moisture vapor may be temporarily generated resulting
in a whitened smoke.
NOTICE: immediately after the engine is started, the engine sound is louder compared to the sound after the engine
is warmed up, and also the color of the exhaust smoke becomes more whitened or more blackened than the smoke
emitted during the normal operation. The engine sound and the color of the exhaust smoke get smoothed after the
engine is warmed up.
NOTICE: due to resonance, vibration might increase while the engine is running at low speed. Increasing slightly the
engine speed reduces the vibration.
4-4