Cascade UTF2-08-1004-1885315, Руководство по эксплуатации и обслуживанию

Страница: 26 / 34

26
6.7.2 Replacing the sliders
In order to replace the sliders, dismantle the arms:

Lower truck upright as far as possible.

Open arms as wide as possible.

Switch off truck power supply.

Remove the semi-spherical joint and the
washer that attaches it to the rod.
ATTENTION : the utmost attention must be paid when sliding the arms off the frame guides,
because it could move and collide with the operator.

Pull the cylinder rod off completely.

Replace worn sliders with original Cascade Italia spares.

Clean and grease the internal surface of the
sliders with a brush.

Re-assemble the arms by performing the
abovementioned steps in reverse order.

Screw the rod partially on to the ring nut or joint.

Apply a film (10mm of thread for rods with
diameters less than 50mm, 20 mm for diameters
from 50 to 80 mm and the entire thread for
diameters greater than 80mm) of medium
mechanical resistance thread-locking glue (e.g.
loctite

243) as shown in diagram.

Fully tighten the rod

Check that the device functions properly. First try using without a load and then with a load.

Perform opening and closing cycles without load.

Repeat the same operations for the other arm.
Fix the arms using a winch by
means of the eyebolt provided and
slide the arms off manually in the
direction indicated by the arrow.
STELO
GHIERA
O SNODO