Casa Del Vetro MTB Acquari Milo 43 Ekoline Black, Инструкция по эксплуатации

Страница: 103 / 144

103
HOW TO FIND A SOLUTION TO THESE DRAWBACKS
WARNING! THE AQUARIUM AND ITS APPLIANCES MUST BE DISCONNECTED FROM THE MAINS POWER SUPPLY BEFORE SERVICING
AN AQUARIUM OR CONDUCTING ANY ACTIVITY THAT ALLOWS DIRECT CONTACT WITH THE WATER.
IF THE LAMP DOES NOT LIGHT UP:

Make sure the aquarium is connected to the mains supply.

The electronic ballast (or the starter in the aquarium version with electromagnetic ballast) could be defective. It must be replaced
with a new one, same type.

The lamp could be defective. It must be replaced with a new one, same type.
IF THE PUMP IS NOISY:

Clean the filtering materials (filter foam, filter wool etc.)

Check the rotor of the pump and clean it.

Check that the water entry isn't clogged.
IF THE TEMPERATURE IS TOO ELEVATED IN THE AQUARIUM:

Check the working of the heater (if supplied).
The high temperature could be due to the lights, if they have been lit for too many hours or if the position of the aquarium is too
close to heating sources (stoves, radiators, windows etc.)
IF ALGAE GROWS ON THE GLASS WALLS OF THE AQUARIUM:
In the freshwater aquarium, algae is the enemy of the plants. The best way to control algae problems naturally is to minimize the amount
of phosphate and nitrate in the water. This is achieved by properly feeding the fish and adding plenty of aquatic plants to the pond.

Scrub the sides of the tank as needed to remove algae. Remove free floating algae.

Change more frequently one third of the water.

Make sure that the tank receives no direct sunlight.
DAMAGED CABLE / PLUG :
If the cord or the plug of the aquarium is damaged, it must be replaced. It must be replaced by the manufacturer or an authorized service
centre or in any case by a person
with a similar qualification.
The cord/the plug must be of the same type.
REPAIRS SHOULD BE CARRIED OUT ONLY BY QUALIFIED TECHNICAL PERSONNEL TO AVOID ANY HAZARDS.
PLEASE NOTE : the cleaning of the external plastic parts have to be done with a damp cloth.
IMPORTANT : NEVER USE SOLVENTS OR SIMILAR PRODUCTS THAT COULD DAMAGE IRREPARABLY THE PLASTIC MATERIAL.