1
10. Flip the stripper downward
to open it.
11. Follow the instruction on
Chapter 2-1 to install the label.
12. Peel off the first label, and
feed the liner through the roller
and the strip bar.
[Note]
The label / paper used for stripper
is suggested to be at least 20mm
in height.
[Suggestion]
When printing with stripper
module, it is suggested to set the
stop position (^E) to 9 (for DT-4)
13. Follow the direction as
shown in figure to feed the liner
across the stripper.
14. Flip the stripper upward to
close it.
15. Press the FEED key to
adjust the position of label and
complete the installation.
8
Содержание BP-DT-4
