Feed the Pole Display connectors down through the Pole Display Bracket
and up through the opening in the scale base. (See fig.)
NOTE: Remove the Ferrite Core before attempting to feed the Display
Connectors into the Pole Display Bracket. Also you may need
to remove the Bracket Cover before feeding the Pole Display
connectors into the Pole Display Bracket.
Bracket Cover
Remove the Platter from the platform and then remove the three rear
cover screws. (See fig.)
TOP REAR VIEW
REAR COVER SCREWS
PRINTER BAY
REAR COVER
PRINTER COVER
Tilt the Rear Cover back and connect the three connectors to their
corresponding receptacle on the Rear Display PCB then install the
Ferrite Core. (See fig.)
Reinstall the Rear Cover using the three screws you removed earlier.
The Pole Display installation is now complete. Now you can Power
on your scale and verify correct operation of the Pole Display.
The Display Pole can turn approximately 180 . However, if the Display Head
does not turn freely loosen the Twist Lock Nut on the Display Pole. (See fig.)
o
Top View
Tighten
Loosen
TWIST LOCK NUT
8
Remove
Ferrite Core
Ferrite Core
