Carver 46 VOYAGER, Руководство пользователя, Страница: 161 / 180

S
ECTION
8 W
INTERIZATION AND
S
TORAGE
4627 11/02
the “Thru-Hull Fittings” portion of Section 9 for the exact location of
the overboard discharge fitting.
4. Open the overboard discharge seacock.
5. Turn the waste/grey water selector Y-valve so that its handle points to
the grey water hose. The Y-valve is located in the engine room on the
starboard forward bulkhead.
6. Turn the “house” battery master disconnect switch to the “ON” posi-
tion.
7. On the Safety Breaker Panel, switch the Main - One circuit breaker
“ON.”
8. On the DC Control Center, switch the Systems DC Main circuit breaker
“ON,” then switch the Waste Pump circuit breaker “ON.”
9. Turn the overboard discharge pump switch “ON.”
10. When a steady stream of antifreeze flows from the overboard discharge
fitting, turn the overboard discharge pump switch “OFF.”
11. Close the overboard discharge seacock.
12. On the DC Control Center, switch the Waste Pump circuit breaker
“OFF.”
13. When you remove your boat from storage and prepare to use it again:
a. Pour 5 gallons of fresh water through each shower and sink drain.
b. Empty the grey water tanks as described in the “Grey Water Hold-
ing System” portion of Section 4 .
c. Charge the grey water tanks by adding deodorizer. Use the brand of
deodorizer recommended by your Carver Dealer.
8.3.9 Exterior
Wash the exterior of the boat, particularly the underwater portions. Re-
move as much aquatic growth as possible while it is still wet. Once the
growth has dried it is more difficult to remove.
Check the zinc sacrificial anodes for deterioration. If the zincs show signs of
deterioration have them replaced before spring launch. Check stainless
steel rails and fittings for signs of rust. Remove rust prior to winter lay-up.
Inspect the underwater portions of the hull. Review anything that looks out
of the ordinary with your Carver Dealer.
Open Closed