OWNER’S MANUAL
SYSTEM OPERATING INFORMATION
124
7
5137 • C8 12/2016
USING THE WATER SYSTEM
The freshwater system is designed to operate the
same as an in-home water system. Open any faucet to
receive fresh water after fi lling, pressurizing and priming
the freshwater system. The pressure in the system
decreases as water draws from the system. The pressure
water pump automatically turns on and increases the
pressure when pressure within the system decreases.
The automated system ensures a steady fl ow of water
any time a faucet is opened.
Occasionally, re-priming may be necessary for a recently
fi lled system or a system that has not been used for
a while. Re-priming is normal and is caused by an
accumulation of air bubbles at the pressure water pump.
To re-prime the freshwater system, repeat the procedure
in
“PRESSURIZING AND PRIMING THE WATER
SYSTEM” on page 122
.
TIP
To obtain a consistent shower temperature, turn on the
cold water faucet fully, and then slowly turn on the hot
water faucet until the water fl owing from the shower
head is at the desired temperature. This method keeps
the pressure water pump running and eliminates widely
fl uctuating temperatures.
WATER HEATER OPERATION
1 ]
Fill, pressurize and prime the freshwater system as
explained in
“PRESSURIZING AND PRIMING
THE WATER SYSTEM” on page 122
. This
process automatically fi lls the water heater.
2 ]
Supply AC power to the yacht. See
“AC POWER
SOURCES” on page 102
for instruction.
3 ]
On the AC control center:
a ]
Switch ON the SHORE circuit breakers.
b ]
Switch ON the WATER HEATER circuit breaker.
4 ]
For more information, refer to the Original
Equipment Manufacturer (OEM) information for
details on operating the water heater.
Never supply power to the water heater while empty;
damage may occur to the heating element. Fill, pressurize
and prime the freshwater system before turning on the
water heater, as described in
FILLING THE FRESHWATER
TANK on page 122
and
PRESSURIZING AND PRIMING
THE WATER SYSTEM on page 122
.
NOTICE
SHOWERS AND SINKS
If supplied, used (gray) water from the sinks and showers
drains into the sump. The sump is located below the
yacht’s waterline. A pump is needed to drain the sump
and discharge its water overboard. See
“Gray Water
System” on page 131
for more information on
drainage.
The sump pump operates automatically when water in
the sump rises above the pump’s manufactured level.
The automatic operation occurs only when the AUTO
SUMP circuit breakers are ON. The breakers are located
on the DC control center.
Shower
A shower is installed in each head.
Sinks
Sinks are installed in the galley, bridge and each head.
Transom Hand Shower (Optional)
The optional transom hand shower supplies warm, fresh
water after swimming. The hand shower is especially
useful when the yacht is run in saltwater. The hand
shower is an integral part of the yacht’s freshwater
system. Simply turn on the faucet and adjust for the
desired water temperature.
Содержание C52 Coupe
