Carver Yachts 45 Voyager 2005, Руководство пользователя

Страница: 104 / 232

I
NTERNAL
S
YSTEMS
S
ECTION
4
94
4527 10/99
This section applies only to the optional air conditioning
system installed at the Carver factory. An air condition-
ing system installed as an aftermarket accessory may
not necessarily operate as described in this section.
For the air conditioning system to operate it needs a
source of AC power (supplied by either a shore power
source or the onboard generator) and a supply of sea
water (either salt or fresh).
The factory-installed air conditioning option consists of
four air conditioning units:
• A 16,000 BTU unit, located beneath the port salon
sofa, to cool the salon and galley. If your boat has
the optional third stateroom, this unit is located
under the sofa in the salon.
• A 16,000 BTU unit, located beneath the port salon
sofa, to cool the pilothouse and guest stateroom
head. If your boat has the optional third stateroom,
this unit is located under the sofa in the salon.
• A 7,000 BTU unit, located beneath the master
stateroom berth, cools the master stateroom.
• A 10,000 BTU unit, located beneath the guest
(forward) stateroom berth, cools the guest state-
room and the master stateroom head.
NOTE: Because the condensation from the two state-
room air conditioning units drains into the sump, the
Auto Sump circuit breaker on the Engine Room Safety
Breaker Panel must be "ON" whenever these two air
conditioning units are on.
The air conditioning system can produce heat when it is
operated in reverse cycle mode. Reverse cycle operation,
however, is affected by the temperature of the sea
water. As sea water temperature decreases so does the
air conditioning system’s ability to produce warm air.
Carver recommends that the air conditioning system
not be operated in reverse cycle mode when the sea
water temperature is below 40 degrees F.
Air Conditioning
System
Producing Heat