Carver Yachts 380 SPORT, Руководство пользователя, Страница: 116 / 131

104 3327 • P2 6/06
WINTERIZATION AND STORAGE SECTION 8
You must use a nontoxic, non-alcohol, RV-type (pink) antifreeze in your
boat’s grey water holding system. Using the wrong type of antifreeze can
damage the grey water holding system. The repair of such damage is
not included under the terms of the Carver Limited Warranty.
3. Pour 3 gallons of nontoxic recreational vehicle antifreeze through the shower
and each sink drain.
4. Under the boat, place a large bucket beneath the grey water overboard
discharge fitting to collect antifreeze pumped out later in this procedure.
5. Open the grey water overboard discharge seacock.
6. Turn the Y-valve to select the grey water tanks.
7. On the DC Control Center:
a. Switch the Main circuit breaker “ON.”
b. Switch the Waste Pump circuit breaker “ON.”
8. Turn the overboard discharge pump switch “ON.”
9. When a steady stream of antifreeze flows from the overboard discharge
fitting, turn the overboard discharge pump switch “OFF.”
10. Close the overboard discharge seacock.
11. Switch the Waste Pump circuit breaker “OFF.”
12. When you remove your boat from storage and prepare to use it again, flush
and pump out the grey water tanks to remove the antifreeze.
Exterior
Wash the exterior of the boat, particularly the underwater portions. Remove as
much aquatic growth as possible while it is still wet. Once the growth has dried
it is more difficult to remove.
Check the zinc sacrificial anodes for deterioration. If the zincs show signs of
deterioration have them replaced before spring launch. Check stainless steel rails
and fittings for signs of rust. Remove rust prior to winter lay-up. Inspect the
underwater portions of the hull. Review anything that looks out of the ordinary
with your Carver Dealer.
Open Closed