Cartoni Malibu 540 2014, Руководство пользователя

Страница: 97 / 136

10
83
110-0001-04EN
Sanitary facility
→ Move the tilting lever (Fig. 61, Pos. 3) of the drain taps (Fig. 61, Pos. B)
either vertical or horizontal and no other position! Twisting the tilting lever
could damage the seal in the drain tap leading to it leaking.
Filling process:
1. Move the blue twist lock (Fig. 61, Pos. 2) on the drain tap (Fig. 61,
Pos. A) crosswise.
2. Press the knob (Fig. 61, Pos. 1) and lock at the same time (Fig. 61,
Pos. 2).
3. Close drain tap (Fig. 61, Pos. B). Move the tilting lever (Fig. 61, Pos. 3)
to the horizontal position to do this.
4. Open all water taps and the spray head and move to "warm".
The water pump pumps the water out of the water tank to the boiler.
5. Keep the water taps open long enough until the water runs our of the
water taps without any bubbles.
The boiler is filled with water.
6. Move all water taps to "cold" and leave open.
The cold water lines are filled with water.
7. Keep the water taps open long enough until the water runs our of the
water taps without any bubbles.
8. Close all water taps again.
Emptying procedure:
1. Switch off the boiler.
2.
Perform the tank emptying (see chapter 10.2.2).
3. Switch off the water pump at the control panel (Fig. 44, Pos. 1).
4. Open all water taps and the spray head and move to the middle position.
5.
Place the spray head with the hose into the shower tray or the sink/wash -
basin in a position that is as low down as possible.
6. Open the drain tap (Fig. 61, Pos. A). To do this, turn the twist lock
(Fig. 61, Pos. 2) to the lengthwise position.
7. Open the drain tap (Fig. 61, Pos. B). To do this, move the tilting lever
(Fig. 61, Pos. 3) to the vertical position.
The water boiler is emptied via the same drain taps.
8. Check if the water runs out of the boiler.
→ After draining the water system, close all taps. Due to the contact-con -
trolled taps, the immersion water pump keeps starting.