5
If necessary, contact a licensed electri-
cian to install an appropriate 15 amp
electrical circuit with correct NEMA re-
ceptacle. Ensure that the plug is acces-
sible after installation.
DO NOT use an extension cord.
Place the cabinet on level ground so that the inside water flows evenly. Lock the
front wheel caster brakes. Adjust the leveling legs so that they are on the floor. If
your floor is not level, adjust the legs so that the unit is level.
NOTE: Unit must
be level in order to function properly.
Leave at least 36 inches (914 mm) at the front of the cabinet, so there is ample
space for opening the doors and pulling the drawers out.
Allow at least a two to six inch ventilation gap between the top of the unit and the
ceiling. Allow at least 2” of space for ventilation at the rear of the cabinet.
Install the anti-tip straps, included with the cabinet.
IMPORTANT: THIS PROCE-
DURE MUST BE DONE BEFORE GOING ANY FURTHER WITH INSTALLA-
TION OR OPERATION OF THE CABINET.
INSTALLATION
Installation procedures must be
performed by a qualified technician with
full knowledge of all applicable electrical
and plumbing codes. Failure could
result in personal injury and property
damage.
Damage to unit due to being connected
to the wrong voltage or phase is
NOT
covered by warranty.
The ground prong of the power cord is
part of a system designed to protect you
from electric shock in the event of inter-
nal damage.
DO NOT cut off the large round ground
prong or twist a blade to fit an existing
receptacle.
CAUTION:
Electrical Shock Hazard
IMPORTANT:
Power cord is 10' long
IMPORTANT:
Not under warranty
WARNING:
Risk of personal injury
Due to varying water quality in different
municipalities, make sure that your facil-
ity water is filtered of sediment and
chemicals before hooking up the fill
lines. Sediment from hard and soft wa-
ter may eventually clog up the pumps
and filters.
IMPORTANT:
FILTERED WATER
REQUIRED
LOCATION
WARNING:
Tipping hazard
Anchor straps
must
be used
to secure unit to a wall. Unit
must
be anchored, using straps along
with the anchor points located in the
upper corners of the back of the unit to
structural supports in the wall behind the
unit.
INSTALLATION OF THE ANTI-TIP STRAPS
Before you operate the cabinet it must be installed, using anchors and straps, to
prevent tipping.
1) Verify that you have these 4 items included with your Garden Chef: (2) ¼-20 X
¾” long screw, (2) washers, (2) 8’ long straps, (4) mounting brackets. (Fig. 1)
2) Using screws, washers, and the mounting plate, mount the bracket to the back
of the cabinet as shown in Figure 2
3) On the wall adjacent to the back of the cabinet, install wall anchors (acquired
by other supplier) at equal height for the type of wall being used (i.e. wood,
drywall, cement block, poured cement)
4) Install the mounting plate on the wall anchors with a screw and washer
(acquired by other supplier) matching the wall anchor.
5) Thread the loose end of the strap as shown in Figure 3 and then through your
wall mounted anchor
6) As shown in Figure 4, thread the loose end of the strap through the buckle
Figure 1
Figure 2
Figure 3
Figure 4
Continued on next page
