18
GB
CARSON Nitro Buggy CNB 204016
Lift the fuel tank lid carefully fill the fuel tank until the fuel level
is just below the top of the fuel tank.
WARNING
Use fuel that is appropriate for nitro car and buggy engines.
Do not use gasoline or diesel fuel! For the break-in period you
should use fuel specifically designed for RX car engines that
contains no more than 16% nitromenthane.
Picture 21
• Using your glow plug wrench, verify that the glow plug is
installed in the cylinder head and tight.
• Open the throttle completely and cover the exhaust opening
in the tuned pipe with your finger.
• Push the shaft of your E.M.S. starter into the flange at the
engine‘s back.
• Push the button at your E.M.S. starter for several short times
until the fuel in the tube reaches the carburettor.
• Remove your finger from the tuned pipe opening and close
the throttle down to the idle position.
• Push the E.M.S. starters button once again a couple of short
times while holding the CNB firmly with one hand.
Picture 22
• Now stick the glow starter with fully charged battery through
the heat sink to the top of the glow plug.
• Keep the carburettor in idle position, firmly hold the CNB
with one hand and push the E.M.S. starter until the engine
starts and runs.
• However the glow starter has to stick onto the glow plug for
around 10 seconds.
Picture 23
