KGAET0201ETK: Installation Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
12
L13F009
Fig. 9 – Vent Located Below Floor with Upflow Furnace and Through-the-Cabinet Venting
L13F010
Fig. 10 – Vent Located Below Horizontal Furnace
Representative drawing only, some models may vary in appearance
TO CODE--APPROVED DRAIN
OR CONDENSATE PUMP
F
D & E
FLOOR
JOISTS
G
B
H
USE MEDIA CABINET ADAPTER OR
CONSTRUCT AN ADAPTER BOX
(FURNACE CANNOT BE SET ON
FLOOR DUE TO SERVICEABILITY)
AIR FLOW
CONFIGURATION FOR VENT AND
/
OR COMBUSTION AIR PIPIING
(See NOTES in Figure 1)
COMBUSTION AIR INLET PIPE MAY TERMINATE IN
WELL VENTILATED CRAWL SPACE (VENTILATED
COMBUSTION AIR) OR EXTERNAL TO STRUC
-
TURE. TRAP KIT MAY ALSO BE APPLIED.
SLOPE UP TO
TERMINATION
1/4-
IN. PER FOOT
Two inch pipe shown.
When another size pipe is
used, discard the 2-in. tee
in the kit and use a field
supplied tee that is the
same diameter as the pipe
being used.
Representative drawing only, some models may vary in appearance
TO CODE--APPROVED DRAIN
OR CONDENSATE PUMP
F
D & E
FLOOR JOISTS
G
B
H
CONFIGURATION FOR VENT AND
/
OR COMBUSTION AIR PIPIING
(See NOTES in Figure 1)
AIR FLOW
SLOPE UP TO
TERMINATION
1/4-
IN. PER FOOT
Two inch pipe shown.
When another size
pipe is used, discard
the 2-in. tee in the
kit and use a field
supplied tee that is
the same diameter as
the pipe being used.