Mounting and wiring
i-Vu® CCN Router
CARRIER CORPORATION ©2021
Installation Guide
All rights reserved
5
To wire CCN devices on Port S1
1
Turn off the i-Vu® CCN Router's power.
2
Check the communications wiring for shorts and grounds.
3
Verify that the
Port S1
485/232 jumper is set to
EIA-485
(left side) and the 2/4 jumper to
485-2w
(right
side).
4
Connect the i-Vu® CCN Router's
Port S1
to the CCN bus. Use the same polarity throughout the network
segment.
Wire this Port S1 terminal...
To this CCN device terminal...
Signal Ground (Pin 5)
G
Net- (Pin 2)
-
Net+ (Pin 1)
+
NOTE
The CCN Shield should be tied/taped back or daisy chained if the i-Vu® CCN Router is not at one end
of the bus.
Содержание i-Vu CCN Router
Страница 4: ......
Страница 16: ......
Страница 17: ...CARRIER CORPORATION 2021 Catalog No 11 808 393 01 1 22 2021...