Mounting and wiring
i-Vu® CCN Router
CARRIER CORPORATION ©2021
Installation Guide
All rights reserved
4
To mount the i-Vu® CCN Router
WARNING
When you handle the i-Vu® CCN Router:
•
Do not contaminate the printed circuit board with fingerprints, moisture, or any foreign material.
•
Do not touch components or leads.
•
Handle the board by its edges.
•
Isolate from high voltage or electrostatic discharge.
•
Ensure that you are properly grounded.
Screw the i-Vu® CCN Router into an enclosed panel using the mounting slots on the cover plate. Leave about 2 in.
(5 cm) on each side of the controller for wiring.
To wire for power
1
Make sure the i-
Vu® CCN Router’
s power switch is in the
OFF
position to prevent it from powering up before
you can verify the correct voltage.
2
Remove power from the power supply.
3
Pull the screw terminal connector from the router's power terminals labeled
24 Vac/Vdc
and
Ground
.
4
Connect the transformer wires to the screw terminal connector.
5
Apply power to the power supply.
6
Measure the voltage at the i-
Vu® CCN Router’s power input ter
minals to verify that the voltage is within the
operating range of 21.6
–
26.4 Vac or 23.4 - 28.6 Vdc.
7
Insert the screw terminal connector into the i-Vu® CCN Router's power terminals.
8
Turn
on
the i-Vu® CCN Router's power.
9
Verify that the Run LED (a dot in the lower right corner of the
Module Status
LED) begins blinking. The
Module
Status
LED will display
8
for about 5 seconds and then reverts to
0,
until controllers have been found and
downloaded. There is a chase pattern when the router is running with no errors.
Mounting and wiring
Содержание i-Vu CCN Router
Страница 4: ......
Страница 16: ......
Страница 17: ...CARRIER CORPORATION 2021 Catalog No 11 808 393 01 1 22 2021...