19
• It takes about 120 minutes to recharge a
discharged battery (but NOT a deep-dis-
charged one). When the battery is fully
charged, the LED display on the USB
charger cable lights up green again.
Note: when supplied, the lipo-battery is al-
ready partially charged. So the first charg-
ing cycle may well take less time.
It is essential to follow the connection se-
quence given above!
Undo the plugged connection on the
Quadrocopter when you are not using the
Quadrocopter. Failure to observe this pre-
caution may cause battery damage!
2b
Insertion of the rechargeable batteries
into the Quadrocopter
• Remove the two clips on the top side of
the Quadrocopter and remove the cover of
the battery compartment. Open the cover
of the battery compartment with the aid of
the enclosed screwdriver.Insert the battery.
Connect the battery in the model. Close
the battery compartment.
• If the LED on the Quadrocopter flashes
slowly, you must change the battery.
Inserting the batteries in the
remote control
3
Open the battery compartment with a screw-
driver and insert the batteries in the remote
control. Please keep in mind the correct po-
larity. Different types of batteries or new and
used batteries are not to be mixed. After
having closed the compartment you can
check all functions of the remote control with
the help of the power-switch on the front.
With the power switch turned ON and
functioning correctly, the top centre LED
on the remote control will light up red. If
the LED control flashes slowly and an
acoustic signal is heard, the batteries in
the controller must be changed.
Frequency bind between model
and remote control
4
The Carrera RC Quadrocopter and the
controller automatically link up renewed
with every operational start-up. If initially
there are any problems with communica-
tion between the Carrera RC Quadrocop-
ter and the remote control, please carry
out a new frequency bind.
• Switch on the controller at the power switch.
• Connect the battery in the model.
• The LEDs on the quadrocopter now flash
rhythmically.
• Push the left-hand joystick, i.e., the throt-
tle control, completely upwards and then
completely downwards.
• The binding has now been successfully
established.
• The LED on the controller now lights con-
tinuously.
• After approx. 5½ minutes, the controller
switches off. Please repeat the link pro-
cedure for renewed use.
•
WARNING! Immediately after switch-
ing it on, place the Quadrocopter on
a flat and level surface. The gyro-sys-
tem will then set itself automatically.
Description of the Quadrocopter
5
1. Rotor system
2. Rotor protection cage (removable
24
)
3. LEDs
6
4. Battery cable
5. Quadrocopter connecting plug
6. Battery compartment
Range of functions of the remote
control
7
1. Aerial
2. Power (ON / OFF)
3. Control LED
4. Gas
Circling
5. Forwards / backwards
right / left banking
ENGLISH
