Carparelli Infiniti C-ZE1, Руководство по эксплуатации

Страница: 12 / 14

22 23
Specifications
Troubleshooting
Specications
• No power
Refer to "Turn power on" on page 8.
• Reverb effect does not operate
While a rhythm pattern is playing, the reverb
effect is not available. Stop the rhythm pattern
first ( p. 12).
• Patch switching does not change
the sound
Is the patch selection method of the C-ZE1
set to "pre-select" ( p. 18) Turn power off and
then on again to return to normal operation.
• High level of noise
Is unit AC adapter being used? Be sure to use
only an adapter for 9 V DC, 300 mA with center
minus plug (ZOOM AD-0006).
• Battery life is short
Are manganese batteries being used? Continuous
operation time is about 12 hours with alkaline
batteries.
Effect types 54
Effect modules max. 8 simultaneous modules
Patch memory User area: 10 patches x 4 banks = 40
Preset area: 10 patches x 4 banks = 40
Total 80 patches
Sampling frequency 96 kHz
A/D converter 24 bit, 128 times oversampling
D/A converter
24 bit, 128 times oversampling
Signal processing 32 bit
Frequency response 20 Hz - 40 kHz +1.0 dB -4.0 dB (10-kilohm load)
Display 2-digit 7-segment LED
Input
Standard mono phone jack
Rated input level - 20 dBm
Input impedance
470 kilohms
Output
Standard stereo phone jack (doubles as line/headphone jack)
Maximum output level Line +3 dBm
(output load impedance of 10 kilohms or more)
Phones 20 mW + 20 mW (into 32-ohm load)
Control input For FP02/FP01 or FS01
Power requirements
AC adapter 9 V DC, 300 mA (center minus plug) (ZOOM AD-0006)
Batteries
Four IEC R6 (size AA) batteries, approx.
12 hours continuous operation (alkaline batteries)
Dimensions 155 mm (D) x 136 mm (W) x 52 mm (H)
Weight 350 g (without batteries)
CARPARELLI ZE-1 CARPARELLI ZE-1
The FCC regulation warning (for U.S.A.)
Thi s
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance w
ith t he i nstructions, m ay c ause harmful i nterference t o radio c ommunications. H owever, t here i s n o
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
For EU Countries
Declaration of Conformity:
This product complies with the requirements of EMC Directive 2004/108/EG and Low
Voltage Directive 2006/95/EC
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of