CarNetix PSU-PC12, Инструкция по установке и эксплуатации

Страница: 12 / 25

CarNetix PSU-PC12 V1.1 Installation Manual
Step 4 – Connect the PSU-PC12 power cable
The the PSU-PC12 includes a power cable for interconnecting the Xenarc SC3 and the PSU-
PC12. Insert the cable into the J2 connector (white 6-pin Molex connector) of the PSU-PC12.
Do not plug the other end of this cable into the SC3 yet.
Step 5 – Test the PSU-PC12 before connecting the Xenarc SC3
It is recommended that you test the output of the PSU-PC12 before proceeding to the next
steps. Turn on the ignition and measure the voltage on the center pin of the round power
connector as shown in the diagram below. The voltage should read approxi12.4
volts.
Figure 4 Measuring the PSU-PC-12 output voltage
Step 6 – Connect the CNX-CA-XSC8 power cable to the Xenarc SC8
Once you have tested for the presence of the proper voltage on the power connector, insert
both the Red/Black power connector and the Green/Black ACPI connector into the SC3 as
shown in the diagram below.
- 12 -