Carlton SP8018 TRX, Руководство пользователя

Страница: 43 / 101

SP8018 TRX MACHINE OPERATION
23
•
Cutter head swing speed should be
adjusted to a rate that will allow cutter
wheel to pass through stump smoothly.
If jerking, bouncing or significant drops
in engine speed occur, swing rate is too
rapid and must be decreased.
•
Swing speed should be determined and
adjusted with the controls in the full
open position.
•
A counter-rotating valve is located
within the hydraulic system to adjust the
speed. Turning the handle clockwise
will open the bypass and slow swing
action. Turning it counter-clockwise
will increase swing rate.
•
Lower spinning cutter wheel to stump
and make a few light passes at stump to
get a feel for the cutting action.
•
Gradually increase cutting action and
work away at stump by swinging cutter
wheel left- to-right-to-left through stump
in a sideways motion. Smooth,
effortless cutting lengthens machine life,
minimizes downtime and is more
profitable in the long run.
•
Continue cutting stump by adjusting
cutting wheel progressively lower until
stump is cut well below ground level.
•
Raise and swing cutter wheel clear of
stump and position machine closer to
stump for next series of passes. Lower
and continue cutting.
•
Continue in this manner until stump has
been removed.
•
Larger stumps may require repositioning
machine to work at best advantages.