▲
▲
26
Installation
Position of Slot
21
End of Programming
28
35
■
Preliminary operations
Before switching the instrument on, make sure that the
power supply voltage corresponds to what is shown on the
side label of the relevant module.
■
Before mounting the modules
To know in which slot every module is to be mounted,
refer to the figure on page 28. For a correct mounting of the
instrument, insert the modules in the relevant slots, then, at
the end, enter the central module, which can be a blind type
module or an RS232 communication module. The central
module will help fixing also the other modules in the relevant
slots. To remove the modules use a screwdriver as shown in
the picture below.
Gently depress the
two fixing tabs.
Directions 1-4.
1
Remove the central module
from its slot: press your
thumb towards points 2-5.
2
Extract the
c e n t r a l
module.
3
Any other slots that are not
used must be filled with the rel-
evant blind plug modules sup-
plied with the instrument.
