AILERON SERVO INSTALLATION
1.
Collect the following parts:
(1) Left wing
(1) Right wing
(2) Servos
(2) 12” Servo Extension
(1) Servo “Y” Harness
2.
Attach the 12” servo extension to the servo.
IMPO
RTANT!
To ensure that any connections locat-
ed inside the wing will not come loose, either when
the wires are pulled, or during flying,
always tape
them securely together with electrical tape.
3.
Starting from the servo hole, insert the servo
extension and the servo wire into the servo
hole
.
Allow the wire to fall straight down through
though the wing till it exits the the hole in the
bottom of the wing at the center
Tape the extension wire to he bottom of the
wing.
Repeat for the other wing half..
1.
Collect the following items:
(2) nylon swing in keepers
(2) 2-56 pushrods threaded one end
(2) 2-56 clevis
(2) silicone clevis retainers
2.
Slide the silicone keeper on the clevis
Screw the 2-56 pushrod into the nylon clevis
so 1/16” of threads extend past the opening
Attach the clevis to the top hole on the aileron
control horn..
3.
Center the aileron servo and make sure the
aileron is aligned with the wing at the root end.
Insert the end of the pushrod into the servo
arm.
Install the nylon swing in keeper to attach the
pushrod.
Repeat for the other aileron.
AILERON SERVOS PUSHRODS
4.
Install the servo into the servo hole and screw
in place using the screws supplied with your
radio
.
IMPO
RTANT!
Check to confirm all control horns are
securely tightened to all control surfaces.
