6
3.
Insert the other gear leg in the hole on the
other side of the fuselage. One hole is at the
back of the slot and the other is at the front
of the slot. The two wires will lie next to each
other in the slot.
Use the two straps and four screws to retain
the gear.
4.
Install the wheels on the axles, as shown.
First the wheel collar goes on, followed by
the wheel, then the second wheel collar, and
the set screw. Tighten the set screw.
AXLE
WHEEL
SET SCREW
WHEEL COLLAR
WHEEL COLLAR
NOSE GEAR INSTALLATION
(1)
Nose gear strut
(2) Wheel Collars and set screws
(1) Wheel
(1) Nose gear steering arm
(1) 1.5mm x 43 cm wire and tube
(1) EZ connector and screw
(1) Nylon Swivel Keeper
2.
place the nose gear pushrod wire onto the
nylon steering arm.
3.
Slide the nose gear gear strut into the bear-
ing and through the steering arm.
Adjust the nose gear till the coil is just off the
fuselage bottom.
Tighten the set screw against the nose gear
in the steering arm.
