Carel Cabinet 230 l/h, Руководство пользователя

Страница: 43 / 48

39
15 Outlet water loss during C1: Water loss from the N.O. S1: Remove and clean the N.O. electrovalve.
normal functioning. valve due to impurities or
defects.
16 Continuous outlet water C1: Water loss from the N.C. S1: Remove and clean the N.C. electrovalve.
loss when the cabinet is valve (at the cabinet head).
OFF.
17 Irregular water flow on C1: Nozzle clogged with dust S1: Remove and clean the atomizing nozzles; if
nozzle, difficult to regulate or impurities coming from necessary clean the line.
by means of the dedicated the air or water line.
adjustment screw. C2: Out-of-range air and S2: Check the values of the pressure at the cabinet output.
water pressures. If the water/air line is very long, measure the
pressure at the atomizing nozzles.
C3: Oil in the air line. S3: Check the conditions of the filter/oil separator of the
compressor.
C4: Nozzle blocked due to S4: Set the OFF cleaning cycle correctly (see page 24).
incorrect cleaning cycle During the OFF routine, pressure must reach 0bar
selection. and the pin inside the nozzle must clean the orifice.
18 The nozzles produce Inverted water/air input Invert the line/water connection to the heads.
water jets without air. connection.
19 The inlet water pressure Insufficient delivery air Check the capacity of the compressor in relation to the
rapidly decreases. As a pressure. consumption of the entire installation.
consequence also the
output pressure decreases.
20 Ambient humidity far The capacity of the entire Adjust the nozzles again (set max. opening; see points
below the set-point. installation has been 12 and 13 above). If this solution doesn't prove satisfactory,
underrated in relation to it is necessary to add further atomizing nozzles in relation
the ambient requirements. to the max. capacity of the cabinet and compressor and
with respect to the conditions of the air to be treated in
the duct.
21 The cabinet instructs the C1: Inputs/outputs mixed up. S1: Check that the I/O of the water and air lines are
electrovalves to open but correctly connected.
there is neither water C2: Insufficient delivery S2: Check the indications of the input pressure gauges.
nor air circulation. pressures.
C3: The electrovalves of the S3: Check the condition of the electrovalves.
lines are clogged.
Keys: C=cause, S=solution