Carefree of Colorado
Wind Smart
Auto-Retract System
15
052987-002R5
D08
Awning Does Not Move When Key FOB Buttons Are Pushed
Before continuing, ensure that the Wind Smart system is working correctly. Reference the following sections as
needed: “Operating the Wind Smart System”
1. Confirm power to Wind Smart control box
--
Correct as required
2. Confirm Mode switch is set to “Power On” or
“Wind Smart On”
-- Correct
as
required
YES
Cable is OK. Confirm that cable is
securely plugged in; go to step 4
3. Check the cable between the RR24 and Windsmart
control box. As a continuity check, Pin 1 of connector 1
goes to Pin 1 of connector 2; pin 2 goes to pin 2; pin 3
goes to pin 3 and pin 4 goes to pin 4
NO
Repair or Replace as required.
4. Confirm that the RR24 is programmed for the Key FOB
--
Refer to “Programming the RR24 for
the Key FOB” on page 11 and retest.
If system does not work; go to step 5
YES 2
nd
Key FOB works. Replace battery
in 1
st
Key FOB and retest, if no
response, 1
st
Key FOB is defective.
5. Program a second Key FOB and test
NO 2
nd
Key FOB does not work; go to
step 6
YES
System works OK. 1
st
receiver is
defective
6. Replace the RR24 Receiver and test
NO
System does not work. Reinstall 1
st
receiver; go to step 7
7. Replace Wind Smart control box
--
Table of Contents
