Carefree of Colorado
Wind Smart
Auto-Retract System
11
052987-002R5
P
ROGRAMMING THE
RR24
FOR THE
K
EY
FOB
1.
Power to the Wind Smart control box must be on.
2. Press and release the “Press to Learn Transmitter” button on the bottom of the RR24 box. The
receiver is in program mode when the red light comes on.
3.
Press and release the
CENTER
button on the Key FOB. The red light will go out after the RR24 learns
the Key FOB signal.
4.
Repeat steps 2 and 3 for each additional Key FOB.
OPERATIONAL NOTES:
•
The RR24 exits the program mode after ten seconds.
•
If the light does not come on in step 2, check the continuity of the cord between the boxes and
repair or replace as required. Pin 1 of the 1
st
connector goes to pin 1 of the 2
nd
connector etc. If
the light still does not come on, the memory is full and must be cleared.
•
If the light does not go out in step 3, the RR24 knows the Key FOB signal or the battery in the
FOB needs to be replaced.
•
To clear the RR24 memory, press and hold the program button for 5 seconds.
•
The RR24 may be programmed for up to 5 Key FOBs. Additional Key FOBs may be ordered
separately.
T
ESTING THE
K
EY
FOB
Prior to testing the remote control Key FOB, the Wind Smart system must be fully installed, tested and operational.
If the system has not been tested, go to “Testing the System” on page 8 before continuing this section.
1.
Ensure that power is on to the Wind Smart control box.
2.
Extend the awning out about half way.
3.
Set the M
ODE
switch to “OFF”.
4. Press each button on the Key FOB. The awning should not
move.
5.
Set the M
ODE
switch to “POWER ON”.
6. Press and hold the E
XTEND
button on the Key FOB for 2 to 3
seconds; then release the button. The awning should extend
out until the button is released
7.
Press and release the R
ETRACT
button on the Key FOB. The awning should retract automatically.
CAUTION
T
HE RETRACT FUNCTION IS AUTOMATIC AND WILL CONTINUE UNTIL THE AWNING IS FULLY
RETRACTED
.
E
NSURE THAT DURING TESTING AND OPERATION
,
NO OBTACLES OR PEOPLE ARE IN
THE WAY OF THE AWNING
.
8. While the awning is retracting, press and release the S
TOP
(center) button on the Key FOB. The
awning should stop when the button is pushed.
NOTE: The retract function will also stop if the extend or retract buttons are pushed once.
9.
Set the M
ODE
switch to “WIND SMART ON”.
10. Repeat steps 6 through 9.
11. If the Key FOB does not operate as described previously, use diagnostics “D08 Awning Does Not
Move When Key FOB Buttons Are Pushed” on page 15.
Key FOB
MODE
AUTO
RETRACT
ON
OFF
POWER
ON
WS007a
Figure 7. Key FOB Test.
Table of Contents
