Carefree of Colorado
Wind Smart
Auto-Retract System
10
052987-002R5
I
NSTALLING THE
RR24
RF
R
EMOTE
R
ECEIVER
1.
Determine the location of the optional RF receiver (RR24):
1.1 Do not mount the RR24 unit near heat producing elements such as LP appliances or engine
exhaust components.
1.2 For best reception, do not mount the RR24 near or on a metal surface.
1.3 Mount the unit with the antenna pointing up.
1.4 The clearance dimensions for the RR24 are shown in Figure 6 on page 10
1.5 The included cable is approximately 60 inches long. Mount the unit close enough to the control
box so that the cord can be connected without stressing the connections.
1.6 Allow adequate room below the box to access the connector jack, programming button and
indicator light.
2.
Position the control box and secure using two (2) #6 x 1/2” screws.
NOTE: If the box is mounted on a surface that is less that 1/2” thick, the screws will protrude
through the opposite side of the surface.
3.
Connect the cable to the RR24.
4.
Route the cable to the Wind Smart control box and connect.
3 7/8”
4 3/16”
TO
EYE POR
T
on RP24
Program
Mode
Press to Learn
T
ransmitter
UP
RR24
1”
Program
Button
Indicator
Light
Key FOB
WS005
Figure 6. Mounting the RF Receiver.
Table of Contents
