Carefree
Installation Manual
F
REEDOM
WM
052563-001r9
5
I
NSTALLATION
U
SING AN
A
WNING
R
AIL
The awning may be mounted using an existing awning rail. Awning rails are not furnished with the awning.
1. Determine the optimum positioning of the awning.
6.
When installed, the bottom of the awning case is 13.3cm [5 1/4”] from the centerlin
e of the awning
rail. The rail must be mounted a minimum of 41.3cm [16.25”] above openings to avoid interference.
NOTE: Height dimension is based on clearance over a 76cm [30"] door extension. The
mounting height will vary 1.9cm [.75"] for every 5cm [2"] change in extension. For longer
extensions, add the calculated difference. For shorter extensions, subtract the difference.
7. The centerline of the awning fabric is offset from the centerline of the awning assembly. To align the
center of the fabric, use the backplate of the awning assembly for measurements.
7.1. Lightly spray the inside track of the awning rail
with a silicone lubricant.
7.2. Using a minimum of two people, lift the awning
up and tilt as shown.
7.3. Hook the mounting rail into the awning rail and
roll down.
7.4. Adjust the position of the awning horizontally as required. It may be necessary to lift the awning so
that it will slide in the awning rail.
7.5. For the motorized awning only:
x
Lift the awning upward slightly. On the coach wall, mark the
location of where the motor wires exit the awning case.
x
Measure and drill one 8mm hole through the outer wall at the mark.
NOTES: Adjust the location as required. Measure to avoid any interior framing, cabinets,
electrical components etc. that could be damaged or interfere with the hole location.
Ensure that the motor cables are accessible after routing in the next step.
This is a preliminary step, the wire and switch installation are completed after the awning is
secured.
x
Route the motor wires through the hole and seal with silicone sealant.
10. Rotate the awning down.
11. Open the awning 14"-18" [35 - 45cm] to allow access to the back plate.
NOTE: To open the motorized awning, momentarily connect the motor wires to a 9-14VDC drill
battery or car battery. If the motor runs in the reverse direction, reverse the leads.
12. Drill three (3) 3/16" [4.8mm] holes
through the back of the case into
the mounting surface and into the
structure. Use care to not drill
through the inner wall.
13. In the awning case, ream out the 3/16" [4.8mm] holes to 5/16" [8mm]. Do not allow the drill to extend
into the wall.
CAUTION
The screws must be located in the open areas of the awning case as shown. The
arms cannot close completely if the screw heads are underneath.
14. Secure the awning using three (3) #14 x 1 1/2" lag screws.
