Carefree
Installation Manual
F
REEDOM
WM
052563-001r9
3
I
NSTALLATION
Two standard methods are available to mount the Freedom awning. The awning may be mounted using a
set of mounting plates that attaches to the vehicle wall (refer to page 3) If using adaptor brackets, follow the
instructions included with bracket kit then proceed with "Mounting the Awning" on page 4. The awning may
also be mounted using an existing awning rail.
Prior to mounting the awning:
x
Review both mounting methods to determine the best mounting method
for the particular application. The mounting brackets require access to the inside of the mounting surface.
x
If there is an awning rail installed, check that the awning rail runs the full length of the awning. The awning
rail must be extremely straight to accommodate the awning mount. The rail must be attached to structural
components for stability.
x
Ensure that the awning will not interfere with light fixtures, exhaust vents, openings, etc.
A
TTACHING THE
M
OUNTING
P
LATES
1. Determine the optimum positioning of the awning.
1.1. The centerline of the awning fabric is offset from the centerline of the awning assembly. To align the
center of the fabric, use the backplate of the awning assembly for measurements.
1.2. The bottom of the mounting plates should be 28cm [11"] above any openings or frames to avoid
interference when the awning is installed.
NOTE: Height is based on clearance over a 76cm [30"] door extension. The mounting height will
vary 1.9cm [.75"] for every 5cm [2"] change in extension. For longer extensions, add the calculated
difference. For shorter extensions, subtract the difference.
Dimensions are based on the lowest pitch with no lift from the vertical support legs.
1.3. Measure each end of the awning position from the ground so that the mounted awning is parallel to
the ground.
2. Mark the position with a chalk line.
3. Determine the correct plate pattern then use the plates as a template and drill 8mm [5/16"] holes through
the vehicle wall to match the plates.
