Cardinal Detecto 854F Series, Руководство пользователя

Страница: 4 / 16

2
SCALE ASSEMBLY INSTRUCTIONS
Refer to Figure Number 1 and follow the instructions below for scale assembly.
1. Assemble wheels to scale base
with four 5/8-11 x 3 1/2" hex head
bolts, four sleeves and eight 5/8 flat
washers. To secure the wheel,
tighten the bolt against the sleeve
to the scale base.
2. Insert column (B) into scale
base assembly (A) and secure with
two 3/8 split lock washers and two
3/8 -16 hex nuts. NOTE: Detecto
decal should be facing toward the
platform.
3. Lower steelyard rod assembly
(C) into column (B).
4. Hook hanger bearing (C1) into
pivot (A1).
5. Column cap (H) may now be
placed over column (B) together
with weight racks (J). NOTE: If
using only one weight rack, we
recommend it be assembled to the
back of the column. Secure with
four 1/4 - 20 x 3/4" hex head bolts
and four 1/4 split lock washers.
6. Attach trig loop (G) to column
cap (H) with two 1/4 - 20 x 3/4"
carriage bolts, two 1/4 split lock
washers and two 1/4 - 20 hex nuts.
7. Guide beam assembly (D)
through the trig loop (G) and back
into the column (B) opening.
8. Attach steelyard rod (C) onto the load loop assembly (F).
9. Secure the fulcrum loop assembly (E) to the column cap (H) with one 1/4-20 x 1" hex head
bolt, one 1/4 split lock washer and one 1/4 flat washer.
10. Hook counterpoise (K) into beam loop assembly (L). Scale assembly is now complete.
FINAL SEALING AND ADJUSTING INSTRUCTIONS
1. Place capacity poise at Zero, move balance ball (D2) to center of adjusting area by turning
zero adjust screw (D1).
2. Remove screw from counterpoise cup (K). Remove sufficient shot from cup (K) until scale is in
balance. NOTE: Screw must be used as part of weight when removing shot.
3. Replace and tighten screw into counterpoise cup (K). NOTE: Beam must arc freely, otherwise,
all bearings and hook connections must be rechecked for proper assembly. Scale is now ready for
operation. (Note: Scale must be set up and operation must be on a level surface. The scale is level
when the air bubble is in the target on the bulls-eye level.)
A
K
L
G
A1
C1
B
C
E
D2
D1
D
F
H
J
J
Figure Number 1
SCALE ASSEMBLY
DIAGRAM