Part Number 3E1086 R2
11
September 2002
Set DIPSW1 as follows:
Switches
On
Off
1
2
3
4
5
6
7
8
1
2
4
8
16
32
Unit
Addresses
Initialise
Normal
2 door software
= keypad on door 2
1 door software
= liftcar reader
2 door software
= no keypad on door 2
1 door software
= door reader
Set DIPSW2 as follows, where 0 = OFF and 1 = ON:
URI Software
vW6.10, vW7.10,
vW9.10
or later versions.
Reader
DIPSW2
12345678
Prox Plus 125, no authorised exit
00000001
Prox Plus 125, with authorised exit
00000101
For further details on software versions refer to Check Software Version in the
Initialisation section earlier in this Installation Note.
CAUTION
Do not fit the lithium battery jumper (J1) before powering up the URI. If the
jumper is fitted you must remove it and wait 10 seconds.
Power up the URI.
The yellow LED (D45) should be permanently ON. This indicates that 5 V is present on
the board.
The green LED (D44) should flash twice, pause, then flash twice again. This is a
continuous sequence while the URI is unitialised and indicates it is processing.
The red LED (D8) should flash if polls are received from the Commander.
Note: A URI can be initialised without being connected to a Commander
!
