9
Step 4: Optional Accessory Connections
(Continued)
Starter Disable Wiring Using a Common Relay
Using the wiring information and diagram below, connect the optional starter disable relay as follows:
A. Locate the “Start Only Wire” coming from the ignition key switch and cut it.
B. Connect the ends of the cut start wire to pins #30 and 87a of the relay pack.
C. Connect the single gray wire harness supplied (with 2-pin black connector) to pin #85 on the relay.
D. Connect pin #86 to the true ignition switched wire from the ignition key.
To test the starter disable system refer to the starter disable testing procedures located in the testing
section of this manual.
Gray Wire
(Ground when Armed Alarm Output)
2-Pin Black
Connector
87
87a
86
85
30
"ACC"
"START"
"OFF"
"IGN"
Cut
Black
Black
Starter
Starter Disable Wiring Using ALA-RPS Relay Pack
Using the wiring information and diagram below, connect the optional starter disable relay as follows:
A. Locate the “Start Only Wire” coming from the ignition key switch and cut it.
B. Connect the ends of the cut start wire to the black wires coming from the ALA-RPS relay pack.
C. Plug in the orange 2-pin plug into the orange socket located at the rear of alarm module.
To test the starter disable system refer to the starter disable testing procedures located in the testing
section of this manual.
87
87a
86
85
30
"ACC"
"START"
"OFF"
"ON"
Cut
Black
Starter
ALA-RPS
Relay Pack
Red Wire
(Ign. Sw12VDC)
Black Wire
(Ground when Armed Alarm Output)
Black
