Step 3: 5-Pin Power Harness Installation
The power harness contains 3 wires and two vacant sockets. Follow the wiring recommendations
enclosed for each wire.
5
First Vacant Socket:
The first vacant wire socket is a low current (300mA) grounded output wire that can be used to activate
the vehicle’s interior lighting system when the security system is disarmed. An additional relay is
required for proper installation (See Optional Accessory Connection for proper wiring).
Second Vacant Socket:
See Optional Accessory Connection for proper wiring.
Red Wire:
(Main Power Input)
Connect the red wire directly to the (+) battery post for best operation of the alarm system. For best
current sensing capability from the alarm’s current sensing circuit, connect the red wire to the constant
power wire coming from the interior dome light.
Black Wire:
(Main Ground Input)
Connect the black wire directly to the frame of the vehicle. Use a bolt and nut to secure the wire. Scrape
away any grease or paint that might prevent a good connection.
Yellow Wire:
(Sw12 Volts From the Ignition Switch)
Connect the yellow wire to a +12 volt wire that is switched on and off by the ignition key. The correct wire
will in12 volts when the ignition key is in the on and start positions. Do not connect the yellow
wire to the “ACC” wire coming from the ignition switch.
Power Harness
First Socket
Second Socket
P
