15
Each specialty feature listed operates in the same manner regardless of the alarm model. Test each feature
by following the procedures enclosed to ensure proper operation.
Remote Panic:
1. Press and hold the PANIC button down for approximately 3 seconds when using the 4-button
transmitter. When using the key transmitter, LOCK button performs as panic.
2. The alarm will begin to sound and the parking lights will begin to flash.
3. Press the UNLOCK button and the siren/horn will stop sounding and the lights will stop flashing.
Note: The remote panic feature has an automatic shut off circuit. When the siren/horn has sounded for
60 seconds, the panic circuit will turn itself off automatically.
Starter Disable:
(Also applies if ALA-RPS2 was installed to interrupt other circuits)
1. Enter the vehicle and close all the entrances.
2. Press the LOCK button on the transmitter.
3. Turn the ignition key to the start position. The engine will not crank over.
4. Turn the ignition key to the Off position and press the UNLOCK button on the transmitter.
5. Turn the ignition key back to the start position and the engine will crank over and start.
Remote Shock Sensor Delete:
(Applies when arming is performed with the transmitter)
1. Press the LOCK button to arm the system (you will get 1 chirp from the horn/siren and 1 flash from
the parking lights).
2. Within 3 seconds, press the LOCK button a second time. You will hear a second single chirp from the
horn/siren and the parking lights will flash a second time. The shock sensor function is now “Off” and
will return to normal function at the next occurrence when the alarm is manually armed.
Note 1: If the chirp functions have been programmed “Off”, you will only get the light flash indication.
Note 2: The remote shock delete function will operate even if the auto arming feature is active as long as
you manually arm the system before the auto timer runs out and arms the system.
Remote Valet Mode Operation:
Activate Valet Mode
1. Turn the ignition key to the "Off" position and open any door.
2. Press and hold down the LOCK +
*
buttons.
3. The door locks will lock and unlock. Release the buttons.
4. The LED will begin to flash every 5 seconds indicating that the system is in Valet Mode.
(continued)
To test the basic functions of the alarm system repeat the following procedures:
1. Turn off the ignition key and exit the vehicle closing all protected entrances.
2. Press the LOCK button on the transmitter. You will hear a siren/horn chirp, the parking lights will flash
one time and the LED status indicator will flash at normal speed.
3. Wait 5 seconds, then open a protected entrance. The siren/horn will begin to sound. Press the UNLOCK
button once again and the siren/horn will stop sounding (No Disarm Chirp Indicator).
Note: If you press the UNLOCK button when the siren/horn is sounding, there are no disarming chirps.
When you press the UNLOCK button when the siren is off, there will be disarming chirps.
4. Follow procedures 2 and 3 for all other protected entrances.
Step 7: General Testing
Step 8: Speciality Feature and Optional Equipment Testing
