docs.carbide3d.com
12/2/19 v1.0
8
Set Up and Calibrate Carbide Motion
With the hardware installed, you now need to setup Carbide Motion control software to recognize and
calibrate your BitSetter.
NOTE:
Carbide Motion v4.26 or higher is required to use the BitSetter. If you have not already done so,
download the latest version of Carbide Motion now at:
Connect to Shapeoko
1.
Open Carbide Motion.
2.
Power on the Shapeoko, then click the Connect to Cutter button. See
Figure 14.
3.
After the software connects, click the Initialize Machine button. This will begin a homing cycle. See
Figure 15
.
Figure 14
Figure 15
