docs.carbide3d.com
12/2/19 v1.0
7
Version 2.4
Beginning with version 2.4d of the Carbide Motion Controller PCB, the controller boards have a purpose-built
port labeled
RESERVED,
which is intended for a touch probe.
1.
Connect the BitSetter:
a.
If you only have the BitSetter, you can plug it directly into the port labeled
RESERVED
as
shown in
Figure 12
.
b.
If you have both the BitSetter and a Touch Probe, use the Probe Adapter PCB as shown in
Figure 13
.
NOTE:
If your 2.4d/e board is missing the
RESERVED
label, connect the Touch Probe using the adapter cable and
follow the directions for connecting version 2.1/2.2/2.3 above.
2.
After your cable is routed to the Carbide Motion Controller, re-install the controller cover or
enclosure. Make sure not to pinch or accidentally loosen any of the cables.
Figure 12
Figure 13
