Carbatec SS-400H, Руководство пользователя

Страница: 22 / 36

FOR TEC HNICAL SUPPOR T CALL 1800 658 111
SS-400H
OPERATION
A scroll saw is fundamentally a curve cutting
tool but which can also carry out straight
and angled edge cuts. Familiarise yourself
with the following important points prior to
commissioning the saw.
• The saw does not automatically cut wood.
You must feed the wood against the saw
blade manually.
• Feed the wood slowly against the saw
blade as the saw blade teeth are small
and cut only while moving.
• All persons carrying out work with the saw
require training. The saw blade may break
easily during this training time while the
operator is still unfamiliar with the saw.
• The saw is best suited for sheets of wood
less than 2.5 cm thick.
• Feed the wood slowly against the blade
and avoid abrupt curves to prevent the
saw blade from breaking, if you wish to
cut wood sheets thicker than 2.5 cm.
• Saw blade teeth blunt over time,
saw blades must be replaced when
they become blunt.
• Try and make sure that the saw blade
follows the grain of the wood in order
to obtain a clean cut.
• The saw speed must be reduced to
minimum when cutting precious and
non-ferrous metals. Appropriate specialty
blades MUST be used.
!
Switch off the saw and remove the mains
supply plug before installing saw blades
in order to avoid injuries caused by
unintentional activation of the saw.
INSIDE CUTS
This saw is suited also to inside cuts, cuts
not starting at the edge of the work piece.
Proceed as follows:
• Drill a 6mm hole in the work piece.
• Loosen the blade tensioner and release
the tension in the blade.
• Place the bore hole over the saw blade
slot in the work bench.
• Install the saw blade through the
hole in the work piece and through
the work blade slot, and fasten the
blade to the holders and re tension.
• When you have completed the inside cut,
remove the saw blade and then remove
the workpiece from the bench.
22