Carbatec SS-400H, Руководство пользователя

Страница: 18 / 36

FOR TEC HNICAL SUPPOR T CALL 1800 658 111
SS-400H
SETTING THE TABLE
SETTING THE TABLE
FOR 90
°
CUTS
Fig. 4 Setting the angle scale
• Release the star knob (A) and bring
the saw bench (B) to a correct angle (D)
in relation to the saw blade (C).
• Use a square to measure the angle
between the blade and the bench.
• Tighten the star knob (A) again when 90°.
NOTE: the angle scale is a useful piece of
supplementary equipment, but should not be
used for precision work. Use scrap wood for
saw tests, adjust the bench if necessary.
NOTE: The bench should not rest
on the motor block, this can cause
undesirable noise and vibration.
SETTING THE TABLE
FOR ANGLED CUTS.
Fig. 4+5
• The saw bench can be positioned at up
to a 45º angle position to the left of the
horizontal position.
• You can read off the approximate angle
by using the angle scale located under the
work bench. For more exact adjustment,
use scrap wood for some saw tests;
adjust the bench if necessary.
• Follow the instructions above before
tensioning the star knob.
Fig. 4
Fig. 5
18
B
C
D
A