Carbatec BS-X3452C, Руководство пользователя

Страница: 12 / 30

10
MITER GAUGE ADJUSTMENT
1. Place the miter gauge in the table slot.
2. Loosen the clamp screw on the miter gauge.
3. Adjust the desired angle of cutting on the miter
gauge.
4. Tighten the clamp screw. (see Figure 20)
SAFETY DEVICE
1. Limit switch (see Figure 21) inside the machine
body for cutting off the power while door
opening during operation.
2. The emergency stop (see Figure 22) can help
you stop the machine immediately once
dangerous situation happens.
REMINDER
Once completing assembly, please test run the machine to ensure it is properly connected to power
and safety components are functioning correctly.
If you find an unusual problem during the test run, please stop the machine immediately. Disconnect
the machine from power and fix the problem before operating the machine again.
Figure 20
Figure 21
Figure 22