Carbatec BS-X3452C, Руководство пользователя

Страница: 11 / 30

9
TABLE PARALLEL ADJUSTMENT
1. Insert table pin into the table groove.(Figure 16)
2. Use the ruler gauge to put it on the table. (Figure
17) Adjust the position of table pin (adjust the
depth of the pin) and adjust the parallel of the
table by using the feller gauge. Tolerance for the
table parallel is within 0.4mm.
3. When adjusting the table, the table edge can
higher than the middle position about 0.4mm
which is acceptable. (Figure 18& Figure 19)
Edge can not lower than the middle part of the
table.
Note: Insert the table pin deeper, the middle part
of the table will be lower.
4. Follow above steps to finish the table parallel
adjustment.
Trouble Shooting:
If the table pin gets stuck, it’s because you push it too
deep. Use a round bar
φ
5mm~
φ
8mm and a soft
hammer to knock the table pin out from inside of the
table. Please be aware of your fingers!
Figure 16
Figure 17
Figure 18
Figure 19