Version 24.02.2012
C1-RNSE
Pa
ge
4
3.
Installation
Switch off ignition and disconnect the vehicle’s battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
Place of installation is behind the head-unit.
3.1.
Interconnecting Interface-box and harness
Plug harness C1C-RNSE into 12pin Molex of Interface-box C1C-RNSE.
3.2.
Connections to head-unit
Remove the head-unit from the dash-board.
Plug female 32pin AMP-connector of C1C-RNSE into male 32pin AMP-socket of head-
unit.
Note:
If the 32pin AMP-socket of the head-unit is already occupied, the vehicle probably has
a factory rear-view camera or a factory TV-tuner. In case of a factory tuner, it must be
uninstalled: disconnect the female 32pin AMP-connector of the factory harness and
disconnect all wires from the factory TV-tuner. In case of a factory rear-view camera you
have ordered/received the wrong product, call for support.
