Carat FASN8016-2, Руководство по эксплуатации

Страница: 30 / 44

30
Operation in cold weather
When operating tools at temperatures near and below freezing, the moisture in the air line may freeze
and prevent tool operation. :
1. Reduce the air pressure to 80 psi (5.5 bar) or less.
2. Removed all fasteners from magazine.
3. Connect air and free-fire (blank-fire) the tool. Slow speed operation tends to worm up the moving part.
CAUTION: Do not store the tool in a cold weather environment to prevent frost or ice formation the tools
operating valves and mechanisms that could cause tool failure.
Operation in hot weather
Keep tool out of direct sunlight as excessive heat can deteriorate bumpers, o-rings and other rubber
parts resulting in increased maintenance.
MAINTENANCE AND SERVICE
Lubrication and maintenance
See graphic F pag. 3
• Use Pneumatic tool oil or a non-detergent oil. Do not use detergent oil or additives as they will
damage o-rings and rubber parts.
• Use a filter and regulator when possible.
• Add pneumatic oil into the air inlet (depending on frequency of tool use), 1 drop per 2500 nails.
• Wipe tool clean daily and inspect for wear. Use solvents only If necessary - Do Not Soak. (Solvents
may damage o-rings and other tool parts)
• Drain compressor tanks and hoses daily
• Clean magazine, pusher, and contact trip mechanism periodically.
• All screws, nuts and fasteners should be kept tight and undamaged. Loose screws result in unsafe
operation and parts breakage.