Carat FASN8016-2, Руководство по эксплуатации

Страница: 29 / 44

EN
G
LIS
H
29
OPERATING THE TOOL
READ SAFETY INSTRUCTION SECTION OF THIS MANUAL
Loading the tool
WARNING:
Always connect air before loading the tool
See graphic C pag. 3
• Press the latch(A) downwards, and pull the magazine cover(B) backwards.
• When filling the magazine, hold the tool so that the nose is not pointing towards own body or
towards any other person. Do not load the tool with nails with the safety trip or trigger depressed
• Load the nails and slide the magazine cover forward as far as the position where it gets locked.
Adjusting depth
„
For SN8025 only :
See graphic D pag. 3
The depth that the staple is driven can be adjusted using the depth adjustment next to the trigger of the
tool.
• To drive the staple shallower, turn the wheel(A) to right to the extent desired.
• To sink a staple deeper, turn the wheel(A) to left to the extent desired.
• Make sure that the trigger and safety move freely up and down without binding or sticking after each
adjustment
Clearing a jammed nail
See graphic E pag. 3
Should a nail jam occur, keep the tool pointed away from you and follow these instructions to clear.
• Disconnect air supply from tool
• Push the magazine latch and slide open
• Remove jammed fasteners from the tool
• Slide the magazine forward unitl it get locked
• Connect air supply and replace staples on to magazine
Do not use on scaffoldings, ladders, and shall not be used for specific application:
• When changing one driving location to another involves the use of scaffoldings,
stairs, ladders, or ladder alike constructions, e.g. roof laths.
• Closing boxes or crates.
• Fitting transportation safety systems e.g. on vehicles and wagons