Carat CARACOUP, Руководство по эксплуатации

Страница: 21 / 44

b- the cutting depth with the locking lever (See
picture 8);
c- the straight cut measurement with the tile
bearing square as well as the ruler placed on
the working table (See picture 6);
d- the cutting adjustment with the specially
provided indicator and ruler placed on the slide
rail.
In order to carry out special working it is possible to
set out any cutting inclination ranging from 0° to 45°
as marked on the machine side (See picture 9).
BEFORE ANY CUTTING MAKE SURE THAT THE
TILE TO BE CUT IS PROPERLY LEANED
AGAINST THE TILE-STOPPER.
DISASSEMBLY OF THE DIAMOND BLADE
Loosen the two nuts on the blade guard and remove it.
Remove the blade fixing nut with a 19 mm wrench
and a 5 mm Allen key.
THE BLADE FIXING NUT HAS A LEFT-HAND
THREAD.
After dismantling the blade, clean the blade flanges
carefully and check them for wear.
Grease any surface with fine oil and go on with the
assembly of a new blade. Check for correct
direction of rotation as clearly indicated on the tool.
MOTOR CARRIAGE ADJUSTMENT
The motor carriage is provided with a register for the
vertical play adjustment. If any excessive play of the
motor carriage should take place, act as follows:
1) Loosen the register fixing nut with a 10 mm
wrench;
2) Screw down the dowel with a 4 mm Allen key
until the play is eliminated;
3) Lock the register again with the fixing nut.
GB
21
1 10 0
9 9
1 11 1
9. Maintenance
8 8
CAUTION !
CAUTION !
CAUTION !
CAUTION !
A5_CARACOUP (850).qxd 22/01/2001 15.33 Pagina 21