SIMPLE™ KEY USER GUIDE
SIMPLE™ KEY USER GUIDE
6
7
5.
Insert the
original key
and turn the ignition to the ON/RUN position. If there are no markings, turn the key
clockwise and stop just short of starting the engine.
6.
Press and release the EZ Installer™ button. You will hear a short beep.
a.
NOTE:
If you hear a series of 5 quick beeps, this indicates that the maximum number of keys have been paired,
and an error has occurred. Please see FAQs to learn more.
7.
Wait 30 seconds, the EZ Installer™ will beep twice. You will then have 12 seconds to complete the next step (step 8).
8.
Remove the
original key
and insert the new key into the ignition.
Do not turn the key
. Then, press and release the
button on EZ Installer™.
a.
NOTE:
If you do not complete this step in 12 seconds, the EZ Installer™ will beep continuously, and an error has
occurred (see FAQs for more information). Unplug the device, remove the key, and begin again at Step 1. If you
do not hear any sound, you have started the pairing process. Continue below.
9.
Wait 60 seconds. When pairing is complete, the EZ Installer™ will beep 3 quick, different pitch beeps.
10.
To pair additional keys, repeat the pairing process for any additional keys, beginning with KEY PAIRING STEP 5.
11.
Leave the EZ Installer™ plugged into the OBD port and continue to STEP 2 (of 2) REMOTE PAIRING.
a.
NOTE:
: If you are not pairing a remote, or your key does not have remote functions, unplug the EZ Installer™. If
the EZ Installer™ is left in the vehicle’s OBD port for more than 20 minutes, an alarm will sound reminding you
to remove it.
12.
To test the new key, start the vehicle.
STEP 1 (OF 2) KEY PAIRING
Instructions have timing requirements. If you wait too long between steps, your vehicle’s computer may time
out, requiring you to start over. Once you begin the pairing procedure, move at a quick and even pace.
NOTE:
If you have a Toyota RAV4 (2006-2010), your vehicle may not have a transponder key. Try starting
the vehicle with your
new cut key
, without completing the steps below. If the vehicle starts and runs for
10 seconds, move on to STEP 2 (of 2) REMOTE PAIRING. If the vehicle does not start or does not continue
running, begin at Step 1 below to pair the key.
1.
Find your vehicle’s make, model, year, and transponder key type in the Compatibility Lookup on pages
4-5. Turn the dial on the EZ Installer™ to the position listed for your vehicle’s make, model, year, and
transponder key type under the column labeled, “Pair Key EZ Installer™ Dial Position.”
a.
NOTE:
If more than one dial position exists for your vehicle, try the PRIMARY dial position first. If you
are unable to successfully pair the key, try the ALTERNATE dial position listed for your vehicle.
b.
NOTE:
One working key and the new key should be present during the pairing process.
2.
Enter the vehicle and ensure all doors are closed.
3.
Begin with the vehicle in PARK and the engine OFF.
4.
Remove the security label from the EZ Installer™ and insert it firmly into the on-board diagnostic (OBD)
port located under the dash.
a. The location of your vehicle’s OBD port can be found in your owner’s manual.
TOYOTA IGNITION POSITIONS
